Choose your model and proceed with following method.
X90J (50”/55”/65”/75”), X85J, X86J (43”/50”/55”/65”/75”/85”), X80J, X81J (43”/50”/55”/65”/75”), XRM-X90J (50”/55”/65”/75”), KM-X85J (43”/50”/55”/65”/75”/85”), KM-X80J (43”/50”/55”/65”/75”) series
If it is difficult to detach the table-top stand with the normal method, please follow the instruction below. For normal method, refer to the How to change the height and position of the Table-Top Stand after it has already been set up article.
Removing the Table-Top Stand with the TV in the upright position
Notes:
- Three or more people are required to detach the Table-Top Stand
- Using flat head screwdriver to detach stand (please add tape to tip of driver to prevent scratch on TV)

-
Be careful not to use excessive force while detaching the Table-Top Stand from the TV or LCD Monitor as it may cause the TV or LCD Monitor set to fall resulting in personal injury or physical damage to the TV or LCD Monitor.
-
As you detach the Table-Top Stand, be careful when lifting the TV because the Table-Top Stand may topple over and cause injury or damage the surface that the TV is sitting on.
- Lift one side of the TV set.

- Using a flat-head screwdriver, insert it vertically into the stand insertion slot.
Note: It is recommended that you attach tape to the metal part of the screwdriver before starting work so that the TV will not be scratched.

- Push up the flat-head screwdriver (so that the handle part comes out to the TV screen side), until the stand comes out a little from the insertion slot. (Repeat the step 2 and 3 for the other side)

- Pull the Table-Top Stand out of the insertion slot by your hands.

Removing the Table-Top Stand with the TV in the laydown position (43”/50” only)
Notes:
- Make sure to place TV or LCD Monitor on a soft cloth on to prevent damaging display's surface.
- Be sure to store the removed Table-top Stand in a safe place, keeping them away from children. You will need them if you want to use the TV or LCD Monitor on a table in the future. The Table-Top Stand cannot be purchased separately
- On a table covered with a soft cloth, place the TV with the LCD screen side down.

- Using a flat-head screwdriver, insert it horizontally into the stand insertion slot.
Note: It is recommended that you attach tape to the metal part of the screwdriver before starting work so that the TV will not be scratched.

- Push down the flat-head screwdriver (so that the handle part comes down to the TV screen side), until the stand comes out a little from the insertion slot. (Repeat the step 2 and 3 for the other side)

- Use your hands to pull the Table-Top Stand out of the insertion slot.
